Click here to view printable .pdf version
P.E.P. TECHNOLOGY©
IN-DEPTH EXPLANATION OF
HIGHLIGHTS ( items 1-11 )
#1 The P.E.P. Cad Converter automatically fixed all drawing errors eliminating the need for the engineering department to correct the errors discussed in #2.
#2 Cad drawing errors AUTOMATICALLY found and fixed by the P.E.P. software
The P.E.P. Cad Converter loads the Cad file into memory and then analyzes each geometry to determine whether the geometry is part of an internal cutout or the outside boundary of the part. Having determined which geometry are to be connected,, the software then checks all the part geometry for errors as defined in the conversion parameter table.
The conversion parameter fields shown below come set with default parameter settings that in most cases never need to be altered. In cases where an engineer places geometry to be cut on a specific layer, as in the case of Whitney’s customer, parameter #9 and #10 can be used to filter out un-necessary text and geometry allowing the files to be converted automatically. As circled, parameter #9 in the picture below was set to yes and the pop up window edited to include By*. This change was required because the valid geometry that engineering wanted cut was located on a layer that started with By. Adding By* to the list of acceptable layer names allowed P.E.P. to convert all 10 Cad files automatically.
HOME EXIT Pages: 01 02 03 04 05 06 07 08 09 10
Measurement Masters, Inc. · One Technology Drive D401 · Irvine, CA 92618
Corporate: (949) 753-7878 Fax: (949) 753-8585 E-mail: Sales@peptechnology.com